StarTech.com NETRS232 Instrukcja Obsługi Pobierz pdf (Strona 7)

Instruction Manual

Installation

Hardware Installation

DIN-Rail Bracket:

Follow the below procedure to install the DIN-Rail bracket to the RS232 device server.

1. Remove the included DIN-Rail bracket, and screws from the package, and align the

DIN-Rail bracket ush onto the back of the device server.

2. Align the bracket’s mounting holes with that of the device servers pilot holes, and

secure the bracket to the device server with the two included screws.

DIN-Rail Mounting:

Follow the below procedure to mount the device server to a DIN-Rail.

1. Tilt the unit, making sure that the metal spring located at the back is positioned on

top of the DIN rail.

2. Push the unit towards the rail until a “click” sound is heard.

Connecting to Terminal Block Power:

The device server is powered by an included Universal Power Adapter, or a 2-wire

10~30V DC power source via the included terminal block.

1. Attach the included power adapter to an AC power source, or follow the below

procedure for terminal block power setup.

2. Gently, yet rmly pull the terminal block connector housing from the device server.

3. Using a small at head screw driver, loosen the screws for the terminal block

connectors.

4. Connect the power and ground wires from your DC power source to the proper

terminal block connectors and fasten the screws. The terminals are marked on the

device server housing.

5. Reinsert the terminal block housing into the device server

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Brak uwag

StarTech.com NETRS232 Instrukcja Obsługi Strona 7